Hinge Configurations

Plain or Standard Type

Leaves lay flat in the same plane in an open

position.                                                      

Reverse Assembly

Neither leaf swaged.  Opposing leaves extend

laterally from opposite side of the pin. Leaves

will not close to a parallel position.

Swaging

Forming one or both leaves within the proximity

of paint clearance toward or beyond the

center of the pin.

One Leaf Half Swaged

One leaf swaged one half of the pin diameter.

One Leaf Full Swaged

One leaf swaged equal to the pin diameter.

Both leaves will be parallel when in closed

position.

Reverse Swaged

One leaf swaged to simulate reverse assembly.

Leaves will not close to a parallel position

Offset

Forming one or both leaves in the proximity of

the paint clearance away from the center of the

pin. When both leaves are offset and in a closed

and parallel position, the dimension between

the leaves will be greater then the pin diameter.

Forming

Special bending of the leaves other than

swaging or offsetting.

Multi Leaf Hinge

Made-to-order hinge with one barrel and several leaves.

Unequal Leaf Hinge

Unequal leaf hinges are available in all material

and gauges. Leaves should be measured from

pin center to outside edge of leaf.

Multi-barrel Hinge

Made-to-order hinge with as many leaves and

barrels as necessary. Variations in barrels and

leaves are available.